Home / Trash Compactor Repair

Compactors that will not start, jam at the bottom of the stroke, refuse to return, or leak odor into the kitchen.
Ring 732-679-5500 and a slot for trash compactor repair usually opens the same day, or the next one at the latest, anywhere across Bergen County. Your technician arrives inside a two hour slot, runs the machine through a proper test instead of eyeballing it, and then explains the finding in words that make sense.
Trash compactors are simple machines built around a heavy screw drive and a chain of safety interlocks, and that simplicity works in your favor. Most of the units we are asked to look at are not worn out at all: they are jammed, out of adjustment, or stopped by an interlock doing precisely what it was designed to do. Replacement units are also hard to source in the sizes older kitchens were built around, so repair is usually the sensible answer.
Our sequence never varies. Testing happens first, the number is named second, and no panel comes off until that number has your agreement. Most jobs close during the opening visit, simply because the vans are loaded around what genuinely breaks on these machines. If an order proves unavoidable we hand you the timescale on the spot and pencil in the return before leaving the kitchen.
There is also the opposite conversation, and we do not dodge it. Some appliances are far enough gone that spending on them throws good money after bad, and when that is the case you will hear it plainly, even though saying so costs us the job. People remember that kind of answer, which is why a large share of our week arrives through recommendation.
Anything we finish is guaranteed for 30 days, in writing, on the paperwork you keep. Manufacturers we handle regularly for this appliance take in GE, KitchenAid, Whirlpool. Our week runs across Paramus, Ridgewood, Glen Rock, Oradell, Fair Lawn, River Edge, Hackensack, Englewood and Fort Lee, every day of it.
The door interlock or the drawer switch. These machines will not run with the drawer even slightly proud of the cabinet.
An obstruction in the drive path or a motor overload that has tripped. We clear the path and check the drive nut for wear.
The directional switch at the top of the stroke, or a drive screw needing cleaning and regreasing.
Debris in the drive chain or a worn drive nut. Continuing to run it turns a small repair into a drive assembly.
A perished drawer gasket or a charcoal filter that has never been changed. Both are inexpensive.
Interlock continuity, motor current under load, drive nut wear and rail alignment.
Interlocks, drawer switches, directional switches, drive nuts, chains, motors, gaskets and filters.
Screw cleaning and regreasing, which resolves a large share of these calls on its own.
Straightening or replacing bent drawer rails and checking ram alignment afterwards.
Gasket replacement and charcoal filter renewal, with advice on how often it actually needs doing.
Every manufacturer below is one our technicians are trained and equipped for on this appliance type.
We Provide Appliance Repair in:
Open every day of the week. You get a two hour slot to plan around and a repair figure settled in advance.
732-679-5500Weekdays 8am until 8pm, Saturday and Sunday 9am until 6pm