Home / Ice Machine Repair

Built-in, undercounter and refrigerator ice machines producing slowly, producing hollow cubes, or producing nothing at all.
Ring 732-679-5500 and a slot for ice machine repair usually opens the same day, or the next one at the latest, anywhere across Bergen County. Your technician arrives inside a two hour slot, runs the machine through a proper test instead of eyeballing it, and then explains the finding in words that make sense.
Ice equipment is where water quality shows first. A machine producing at half its rated output is usually reporting on the water reaching it rather than on a broken part, and northern New Jersey supplies carry enough mineral content to scale an evaporator plate within a couple of seasons. We measure inlet pressure and water condition before quoting a part.
Our sequence never varies. Testing happens first, the number is named second, and no panel comes off until that number has your agreement. Most jobs close during the opening visit, simply because the vans are loaded around what genuinely breaks on these machines. If an order proves unavoidable we hand you the timescale on the spot and pencil in the return before leaving the kitchen.
There is also the opposite conversation, and we do not dodge it. Some appliances are far enough gone that spending on them throws good money after bad, and when that is the case you will hear it plainly, even though saying so costs us the job. People remember that kind of answer, which is why a large share of our week arrives through recommendation.
Anything we finish is guaranteed for 30 days, in writing, on the paperwork you keep. Manufacturers we handle regularly for this appliance take in Frigidaire, GE, KitchenAid, LG, Monogram, Samsung, U-Line, Viking, Whirlpool. Our week runs across Paramus, Ridgewood, Glen Rock, Oradell, Fair Lawn, River Edge, Hackensack, Englewood and Fort Lee, every day of it.
Scale on the evaporator plate, a partially closed inlet valve, or an ambient temperature above the machine rating.
A short fill or low supply pressure. Cloudiness is mineral content, which is a filtration matter.
The inlet valve, a frozen supply line, or a saddle valve that was never fully opened.
A blocked drain line or a stalled drain pump, most often debris in outdoor installations.
A tired harvest heater or a thermostat reading late, so the ice bridge freezes back onto the plate.
Inlet pressure, fill volume, plate temperature and harvest timing, measured across a full cycle.
Inlet valves, harvest heaters, thermostats, ice-maker modules, drain pumps and control boards.
Evaporator plate and water path treatment, which restores output on most slow machines without a part.
What a filter on the supply line will and will not do, said plainly.
Drain and inlet work on outdoor rated undercounter machines, which wear differently from indoor units.
Every manufacturer below is one our technicians are trained and equipped for on this appliance type.
We Provide Appliance Repair in:
Open every day of the week. You get a two hour slot to plan around and a repair figure settled in advance.
732-679-5500Weekdays 8am until 8pm, Saturday and Sunday 9am until 6pm